These pages are intended to display aspects of my activities and to highlight items on which I would appreciate help.
The first challenge was to fit Dingham couplings to one end of a couple of items to use as links for my wagons that may run on my club's new layout: I use 3 link but the club has standardised on Dinghams.
These have been lettered with home printed transfers, black with transparent letters applied over white paint. It would seem the the transfers have slightly shrunk revealing white surrounds: touching up before any exhibition is called for.
Here's a model that is a good demonstration of success and failure. The boiler fittings were my first attempt at 3D printing and I was pleased with the results. The chassis was my second attempt at outside frames and CSBs and was a failure: it was too wide over the crankpins and I managed to get superglue in the bearings! A new chassis is under construction.